Second one is about changing serpentine belt tensioner. Even if there is no need to change it, one need to remove belt and all related components to get access to the water pump.
Both these clips are probably all what you need to know to replace water pump on the Ford Taurus 1996-2006 year. I myself cannot add much to that apart of telling some additional tips regarding tools used.
- From my experience set of metric wrenches 8,10,13,15 and the same set of sockets gives enough flexibility to unscrew and screw back all bolts of this project. Just pay an attention that 13 mm socket has to be deep. Regular short socket will be not good for some bolts mounting water pump.
- To unscrew and then put back belt tensioner there is need in torx bit. Unfortunately second video mistakenly states that bit has to be T27 size. This is wrong. For me size T50 worked well.
- Second video shows nice tip of attaching bigger wrench to the 15 mm, making release of tensioner easy. Like this:
- That worked for me, apart of the fact that due to my inexperience 15 mm wrench slipped out of my hand and fell down. I had a trouble to get it back. To avoid such a mistake again I put some tape on the joint. Because of that the pair of wrenches worked as single tool. After the job done it was easy to remove tape and separate wrenches.
- One of dis-assembling steps is to detach heater hose from the water pump. That sounds easy, but... I tried to pull hose as hard as I can without any success (later on I found that big buildup at the end of water pump pipe, as seen on first picture, was the cause) . Then I watched first video one more time and at 1:47 found the answer. Mechanic used special hook to separate hose form the water pump pipe. I made myself similar out of inexpensive awl. That helped.
No comments:
Post a Comment